BlueWater 500131 3 Foot Powder Coat Safety Rail 2000 Kit consisting of 1 counterweight base, 1 3 foot rail section and 2 locking pins.  The SafetyRail 2000 is a portable counterweight non-penetrating guardrail system that does not require use of any tools.  This kit is made up of one 300014 counterweight base, one 500105 3 foot SafetyRail 2000 section and two 100016 locking pins.  The counterweight base has four slotted entry ports to provide a wide range of rail placement.  Rubber pads on underside of base protects roof surface and provides stability on slippery surfaces.  The 108 lb base has a lifting point to accommodate use of EZ Mover dolly.  The locking detent pin secures the 3 foot rail to the base providing a visual means of verifying that it is locked into place.  The 1-5/8 inch steel tubing top rail measures 42 inches above work surface.  Bright, safety yellow powder coat finish.  Each rail section includes tube with set-up instructions.  Guardrail systems require outrigger rail section at each end of the run.  SafetyRail 2000 system has been tested to meet OSHA 1910.23 and 1926.502 requirements for guardrail systems.

• SafetyRail 2000 does not require penetrating roof surface.
• Kit consists of counterweight base, 3 foot rail section and two locking pins.
• Made in USA.
• Bright, safety yellow powder coat finish.
• Rail section made from 1-5/8 inch steel tubing.
• Base dimensions 21-1/4 21-1/4.
• The 4 slotted base entry ports provide wide range of rail placement.
• Rubber pads on underside of base protects roof surface and provides stability on slippery surfaces.
• Base includes lifting point for use with EZ Mover dolly.
• Locking detent pin secures rail section to base.
• Complies with OSHA regulations 29 CFR 1910.23 and 1926.502.
• Kit weights 124 lbs.
• CALL FOR FREIGHT ESTIMATE 614/876-8698.