BlueWater 500209 10 Foot Powder Coat ParaRail Kit consisting of 1 counterweight base, 1 ParaRail section and 2 locking pins.  The ParaRail is a portable or permanent counterweight non-penetrating guardrail system designed to provide protected access to the leading edge on flat roofs or parapet walls.  Ideal solution for providing fall protection for a number of roof edge activities including, maintaining security cameras, lights, antennas and drains.  Makes an excellent protected area for hoisting tools and materials.  This kit is made up of one 300014 counterweight base, one 10 foot ParaRail section and two 100016 locking pins.  Each ParaRail is fabricated to the specific size parapet of the building.  Outriggers are required for every ParaRail application, even if it is part of a continuous run.  The 1-5/8 inch steel tubing top rail measures 42 inches above work surface.  Bright, safety yellow powder coat finish.  Each rail section includes tube with set-up instructions.  The counterweight base has four slotted entry ports to provide an infinite range of rail placement.  Rubber pads on underside of base protects roof surface.  The 108 lb base has a lifting point to accommodate use of EZ Mover dolly.  The locking detent pin secures the 10 foot ParaRail to the base providing a visual means of verifying that it is locked into place.  ParaRail system has been tested to meet OSHA 29 CFR 1910.23 and 1926.502 requirements for guardrail systems.

• ParaRail does not require penetrating roof surface.
• Kit consists of counterweight base, 10 foot ParaRail section and two locking pins.
• Made in USA.
• Can be used as a portable or permanent guardrail system.
• Designed to provide fall protection while working at roof edge on a flat roof or parapet wall.
• Ideal for providing fall protection when maintaining roof edge security cameras, lights or antennas.
• Each ParaRail is custom made to your parapet wall requirements.
• Outriggers are required when using ParaRail system.
• Bright, safety yellow powder coat finish.
• Rail section made from 1-5/8 inch steel tubing.
• Base dimensions 21-1/4" X 21-1/4".
• The 4 slotted entry ports provide infinite range of rail placement.
• Rubber pads on underside of base protects roof surface.
• Base includes lifting point for use with EZ Mover dolly.
• Locking detent pin secures ParaRail section to base.
• Complies with OSHA 29 CFR 1910.23 and 1926.502.
• Kit weighs 170 lbs.
• CALL FOR FREIGHT ESTIMATE 614/876-8698.