Home > Fall Protection Equipment >

SAPS SAP21D Safety Anchor Post System
SAPS SAP21D Safety Anchor Post System
 
Alternative Views:

For pricing information, click on the pricing tab below or call 614-876-8698.

Description Specs Pricing
 
SAPS SAP21D Safety Anchor Post System For Use On Elevated Surfaces; Parapet Walls In All Concrete Construction. The post is surface mounted to the concrete. The SAPS Safety Anchor Post has a built-in stem coil rod that extends from its base. The protruding coil rod is threaded into the embedded insert. The SAPS post rotates clockwise by hand until it is secured. An attached tightening arm provides final tensioning to the concrete surface. The SAPS SAP21D is a temporary guardrail post with a swivel D-ring near its base that is an approved fall arrest anchor. The swiveling D-ring provides fall protection while installing mid and top rails. The tubular post exceeds OSHA's 200 pound side load requirements. Designed for use on elevated surfaces that do not meet the 42 inch height requirement. The SAP21D has a unique rail clamping system that pinches the rails against the post rail bracket. Does not require cleating of rail sections. The vice clamp greatly reduces installation time of rails and does not damage wood rails allowing re-use on the next job. The rail brackets on the post rotates for ease of installation. The average time to install 32 feet of SAPS guardrail including rails is 2 to 2-1/2 minutes. Your fall protection needs can be met by ordering your precast with preset embeds.