SAPS SAP42D Safety Anchor Post System For Use In All Concrete Construction. The post is surface mounted to the concrete. The SAPS Safety Anchor Post has a built-in stem coil rod that extends from its base. The protruding coil rod is threaded into the embedded insert. The SAPS post rotates clockwise by hand until it is secured. An attached tightening arm provides final tensioning to the concrete slab. The SAPS SAP42D is a temporary guardrail post with a swivel D-ring near its base that is an approved fall arrest anchor. The swiveling D-ring provides fall protection while installing mid and top rails and for leading edge tasks. Provides an anchor point every 8 feet. The tubular post exceeds OSHA's 200 pound side load requirements. The SAP42D has a unique rail clamping system that pinches the rails against the post rail bracket. Does not require cleating of rail sections. The vise clamp greatly reduces installation time of rails and does not damage wood rails allowing re-use on the next job. The rail brackets on the post rotates for ease of installation. Includes kick plate bracket when needed. The average time to install 32 feet of SAPS guardrail including rails is 2 to 2-1/2 minutes. Your fall protection needs can be met by ordering your precast with preset embeds. Ideal for precast girder beams for bridges, precast box girder bridge segments and precast culverts for easy access and water proofing application. Use Hilti or Simpson drop-in anchors for cast in place use.

• Greatly reduces installation time and labor costs.
• Requires minimum concrete thickness of 6 inches.
• Minimum concrete strength of 2,500 PSI.
• Meadow Burke B-75 6 inch wall brace insert embed approved for precast use with the SAP42D post.
• Use 3/4" Hilti HDI (-L) w/3-3/16" embed or 3/4" Simpson DIA B75 w/3-1/8" embed for projects where concrete has already been poured.
• Optional kick plate bracket available for applications when needed.
• Very rugged construction.
• Surface mounted to concrete slab for safe, secure and quick installation.
• Post includes tightening arm that aids in securing thread mount post to embed.
• Vice clamp rail brackets secures rails without having to cleat them and allows them to be re-used.
• Swivel D-ring is an approved fall arrest anchor point.
• Guardrail system exceeds OSHA 200 lb lateral load requirements.
• Maximum spacing of SAP post is 8 feet.
• SAP42D post system requires no tools for installation.
• Braced base plate for maximum support.
• Made in USA.
• Weight 30 lbs.
• Meets or exceeds OSHA standards.