SAPS SAP42H Safety Anchor Post System for use in all concrete construction. The post is surface mounted to the concrete. The SAPS Safety Anchor Post has a built-in stem coil rod that extends from the base. The protruding coil rod is threaded into the embedded insert. The SAPS post rotates clockwise by hand until it is secured. An attachment tightening arm provides final tensioning to the concrete slab. The SAPS SAP42H is a temporary guardrail post that exceeds OSHA's 200 lb side load requirements. The SAP42H has a unique rail clamping system that pinches the rails against the post rail bracket. Does not require cleating or rail sections. The vise clamp greatly reduces installation time of rails and does not damage wood rails allowing re-use on the next job. The rail brackets on the post rotate for ease of installation. Kick plate bracket available when required. The average time to install 32 feet of SAPS guardrail including rails 2 to 2-1/2 minutes. Your fall protection needs can be met by ordering your precast with preset embeds. Ideal for precast girder beams for bridges, precast box girder bridge segments and precast culverts for easy access and water proofing application. Use Hilti HDL, 3-3/16" or Simpson DIAB7S, 3-1/4" drop-in anchors for cast in place use.

• Greatly reduces installation time and labor costs.
• Requires minimum concrete thickness of 6 inches.
• Minimum concrete strength of 2500 PSI.
• Meadow Burke B-75 6 inch wall brace insert embed approved for precast use with the SAP42H post.
• Use 3/4" Hilti HDI (-L) w/ 3-3/16" embed or 3/4" Simpson DIA B75 w/ 3-1/8" embed drop in anchors for projects where concrete has already been poured.
• Optional kickboard bracket available when needed.
• Very rugged construction.
• Surface mounted to concrete slab for safe, secure and quick installation.
• Post includes tightening arm that aids in securing thread mount post to embed.
• Vice clamp rail brackets secure rails without having to cleat them and allows them to be re-used.
• Guardrail system exceeds OSHA 200 lb lateral load requirements.
• Maximum spacing of SAP post is 8 feet.
• SAP42H post system requires no tools for installation.
• Brace base plate for maximum support.
• The rail brackets rotate for ease of installation.
• Made in USA.
• Weight 19.3 lbs.
• Meets or exceeds OSHA standards.